Senzeal | Aquarium Fish & Aquatic Plants Blog
Senzeal aquarium blog is for fishkeepers who want to know more about planted aquarium, aquatic plants, fish keeping such as goldfish, betta fish and tropical fishes. We will also recommend you some aquarium supplies you may need...
By Senzeal | 23 September 2020 | 0 Comments

Installation and use of fish tank filters.

Installation and use of fish tank filters.

How to install the filter
1. Physical filter installation
How to install the fish tank filter? First, install the physical filter, that is, lay the filter cotton on the bottom of the fish tank, and then place four magic carpets with hairballs to block the impurities. This is very helpful for installing the built-in filter later.
2. Place the filter
Hold the outer frame of the filter with your hands, put the seal of the filter upward, and gently put it into the fish tank without any collision with hard objects.
3. Insert the rubber tube
Insert the ventilation rubber tube above the filter. When installing, pay attention to the power line as far as possible from the water surface. You can buy a sticky glass tip to fix the wire on the edge of the fish tank wall.
4. Add adsorption ball to the filter
Add the filter ball to the inside of the filter so that it can absorb impurities in the water quality of the fish tank after being plugged in later. Furthermore, together with the installed physical filtration, it perfectly purifies the water quality of the fish tank.
5. Turn on the switch
Finally, turn on the external switch to operate. If the sound is very low, it means that it is installed and can be used directly; if there is noise, it may be a quality problem, or it is caused by improper installation, you can reinstall and try it. At this point, the installation of the fish tank filter is over.

How to use fish tank filter
1. According to the direction of water flow, install the fish tank filter system in the order of water inlet, (water pump), physical filtration, chemical filtration, biological filtration, and water outlet.
2. Put the filter into the aquarium and fix it on one side with a suction cup.
3. Make sure that the filter is placed in a suitable location. When using it, it must be matched with the corresponding detection instrument to control the water quality.
4. Be careful not to use it for 24 hours, otherwise, the filter effect will be reduced.
5. The method of using different fish tank filters will be slightly different, so it is necessary to perform specific operations according to the specific situation.

Leave a Reply

Your email address will not be published.Required fields are marked. *
Name
E-mail
Content
Verification code